Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

ASA Standby VPN not working

This is what’s going on:

I configured two ASA 5545 appliances in failover mode (active/standby). We are currently using these appliances for only VPN connections. To be specific, remote VPN using AnyConnect.

 

Whenever I failover to the standby appliance, which is the secondary in the configuration,  my VPN does not work. When I failover to the primary it works just fine.

Is there something i am doing wrong? why is not working when i fail it over?

thanks

1 REPLY

Perhaps the certficate wasn't

Perhaps the certficate wasn't synchronized to the standby unit? Check the ASDM logs and do a "write standby" on the primary CLI

Michael Please rate all helpful posts
29
Views
0
Helpful
1
Replies