One MPLS leased line is connected with SiteA to SiteB. and Internet connectivity is running with Dial-up connection on both site,I want to configure
one port for Leased Line and one port for internet connection (VPN connectivity with internet). this is for if leased line is down for any reason then with vpn connection they can access the remote server at SiteB .
I have configured the Internet connection in Wan port ,and put the Optional wan port as DMZ (because we can use only one wan port at a time ).but remote site is not accessing ,lease line is working properly without SA540.when I attached SA540 remote site is not accessing.ISP have configured,all the routes,
I am using cisco SA540 , My question is can I able to connect both remote site and accessing internet at a time with the help of these 2 wan ports ?
Hi every one!!!When you are configuring a remote VPN connection, there
are some steps that are lost on the path. Here you can see those steps.
A) In your Cisco device: 1. Ensure you don´t have any rule denying the
traffic between the device and the remote...
You have a Cisco Unified Communications Manager (CUCM) system and want
to configure a SPA112 analog telephone adaptor (ATA) to register to the
CUCM so that you can use up to two analog phones or similar FXS devices
with the CUCM.In this application note, ...
Introduction: This document describes how to connect SG300 with Catalyst
switch via STP. Spanning Tree Protocol (STP) is a Layer 2 protocol that
runs on mainly on switches. The specification for STP is IEEE 802.1D.
The main purpose of STP is to ensure tha...