Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

ISA500: How do I configure a second WAN-IP-Range on the same WAN-line?

I have an ISA570 and my ISP has put the additional IP-Range on the same WAN-line as the existing one. How to configure this? Regards and many thanks Jens

Everyone's tags (1)
1 ACCEPTED SOLUTION

Accepted Solutions

Hi @jens.leipziger@...,But

Hi @jens.leipziger@...,

But the ISP just incremented the mask of your range or put an additional range totally different?

In case that It has assigned a totally different subnet, you cannot configure the ISA with a "secondary" IP range.

You can do it with Cisco routers and some L3 switches with the "ip address x.x.x.x secondary" interface configuration command.

See the following link to more information about the ISA configuration:

http://www.cisco.com/c/en/us/td/docs/security/small_business_security/isa500/administration/guide/ISA500_AG_book.pdf

Don't forget to rate

Rgrds,

Martin, IT Specialist

 

1 REPLY

Hi @jens.leipziger@...,But

Hi @jens.leipziger@...,

But the ISP just incremented the mask of your range or put an additional range totally different?

In case that It has assigned a totally different subnet, you cannot configure the ISA with a "secondary" IP range.

You can do it with Cisco routers and some L3 switches with the "ip address x.x.x.x secondary" interface configuration command.

See the following link to more information about the ISA configuration:

http://www.cisco.com/c/en/us/td/docs/security/small_business_security/isa500/administration/guide/ISA500_AG_book.pdf

Don't forget to rate

Rgrds,

Martin, IT Specialist

 

84
Views
0
Helpful
1
Replies
CreatePlease to create content