I'm trying to set remote VPN connection to my factory's netowrk using IPsec VPN, I followed IPsec VPN creation wizard with the following information:
Internal protected network: 192.168.1.* ISA500 LAN IP: 192.168.1.3 ISA500 WAN IP: 192.168.75.3 (connected to ADSL router)
ISA500 gateway: 192.168.75.1 (ADSL router IP) ADSL router internal IP: 192.168.75.1 (connected to ISA500) ADSL router external IP: our public IP
IPsec information: IKE authentication method: pre-shared key Pool range for client LAN: 192.168.85.100 - 192.168.85.200 Zone access control: Permitted to all zones Primary DNS: 192.168.1.12 No split tunnel or split DNS configured
Using Cisco VPN client from external netowrk, I can connect and authenticate successfully to the ISA500, so I'm VPN connected.
Just a quick question if you didn't solve this yet.
Is your personal home network also set to the same range of 192.168.x.x.
Usually there can be routing problems when this is true. I usually try to stay out of the default personal router dhcp ranges.
Article ID:3091 Reboot and Factory Default Reset on ISA500 Series
Integrated Security Appliances Objective Reboot or restart of the
network device is made when certain changes in the settings need reboot
or if the device is frozen. The configuration setti...
Article ID:3403 WAN Quality of Service (QoS) Policy Profiles Settings on
ISA500 Series Integrated Security Appliances Objective Wide Area Network
(WAN) Quality of Service (QoS) policy profiles manage traffic through
classed-based profiles. These profiles ...
Article ID:2922 Cisco QuickVPN Installation Tips for Windows Operating
Systems For a video showing installation tips on Quick VPN, visit
http://youtu.be/hHu2z6A78N8 Objective Cisco QuickVPN is a free software
designed for remote access to a network. It is...