I need to setup NAT thru my VPN tunnel on my SA520 but can't seem to figure out how to do it. My LAN IP of my SA520 is 172.24.1.2 and I have an internal route to a layer 3 switch on my network with a VLAN of 192.168.2.0/24 (all routes in place on SA520). I need all traffic from the 192.168.2.0/24 going thru a VPN tunnel on the SA520 to be translated to 172.25.1.0/24 IP. I know how to do this on other Cisco devices, but can't figure it out on the SA520. Any suggestions / help would be greatly appreciated.
Reboot and Factory Default Reset on ISA500 Series Integrated Security Appliances
Reboot or restart of the network device is made when certain changes in the settings need reboot or if the device is frozen. The configuration...
WAN Quality of Service (QoS) Policy Profiles Settings on ISA500 Series Integrated Security Appliances
Wide Area Network (WAN) Quality of Service (QoS) policy profiles manage traffic through classed-based profiles. These pro...
Cisco QuickVPN Installation Tips for Windows Operating Systems
For a video showing installation tips on Quick VPN, visit http://youtu.be/hHu2z6A78N8
Cisco QuickVPN is a free software designed for remote access to a ne...