Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

Old configuration after power loss to Primary in ASA 5200 Active\Active pair

Hi,

I have two ASA 5200's in a active\active pair running 8.2. The power was lost to the primary device, was restored. but now the configuration, ip addreses etc are old (over a year). what would cause this? When ever we make a change ot the config in the ADSM we always "Apply" and "Save", should we do more than this?

Thanks

Stuart 

Everyone's tags (1)
1 REPLY
Cisco Employee

You said that you are running

You said that you are running active/active but then you said that the power was lost to the "primary unit." Can you confirm if you are running active/standby or active/active with virtual contexts

 

Thank you for rating helpful posts!

66
Views
0
Helpful
1
Replies
CreatePlease to create content