Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

SA 520 packet capture issue

Gang,

Working on a couple of SA 520's and I'm trying to debug a packet capture issue.

Firmware is 2.1.71, just upgraded last week.

I'm trying to capture packets on the Vlan interfaces, but if I select anything other LAN, it says 'Selected interface not found.'

The choices are: LAN, LAN20, LAN100, Dedicated WAN, Optional Port.

The other 'odd' issue is that when the routing table is diaplayed, there's interfaces called:bdg1, eth1, bdg100, and bdg20.  Shouldn't the two sets of interfaces match???

yes, there are three VLANs.  1 - Default, 20 - Data, and 100 for VoIP.  each has their own  */24 subnet.

Anyone else see this problem?

Trying to figure out a VLAN problem, and a packet trace would be great!

--

Larry

Everyone's tags (2)
1131
Views
0
Helpful
0
Replies