I have been testing a SA 520W. I have setup a couple different vlans, one for and one for voice. I have inter vlan routing enabled. When I try using SSH to get to my PBX it seems to only sort of work. I connect but it seems as though it is dropping packets. My PBX is a linux box so when I check the contents of a directory with the ls command it starts listing then will freeze for up to a minute before showing the rest. If I install another device with the same vlan config it works fine with no freezing.
Also any information on when/if the SA series will be able to functon as a DNS server?
This device is not much cheaper than an 881 I recently purchased but seems far more crippled. What is the reason for this?
Hi every one!!!When you are configuring a remote VPN connection, there
are some steps that are lost on the path. Here you can see those steps.
A) In your Cisco device: 1. Ensure you don´t have any rule denying the
traffic between the device and the remote...
Introduction: This document describes how to connect SG300 with Catalyst
switch via STP. Spanning Tree Protocol (STP) is a Layer 2 protocol that
runs on mainly on switches. The specification for STP is IEEE 802.1D.
The main purpose of STP is to ensure tha...
You have a Cisco Unified Communications Manager (CUCM) system and want
to configure a SPA112 analog telephone adaptor (ATA) to register to the
CUCM so that you can use up to two analog phones or similar FXS devices
with the CUCM.In this application note, ...