I'm trying to find out how to bypass content filtering on a per user or machine Mac/IP? Basically we want it enabled company wide but the owners would like to bypass the filter on their machines.. Any help or direction is appreciated..
We utilize ProtectLink Web with our SA540, and it allows this functionality.
Under ProtectLink -> Approved Clients -> Click Add -> Enter a single or range of IPs to exclude from URL Filtering.
Here is what is under Help for the Approved Clients page.
Approved Client IP Configuration
This page allows you to add a new entry or edit the configuration of an existing entry. The details will then be displayed in the Approved Clients List on the Approved Clients page. Web Protection will not restrict URL requests from these IP addresses. For example, 188.8.131.52 - 184.108.40.206 will exclude all the IP addresses that fall in the range.
IP Address Type: Select Single to add a single IP address, or select Range to enter a range of IP addresses.
Start IP Address: Type the starting IP address.
End IP Address: Type the ending IP address. This field is enabled only if Range is selected in the IP Address Type.
Hi every one!!!When you are configuring a remote VPN connection, there
are some steps that are lost on the path. Here you can see those steps.
A) In your Cisco device: 1. Ensure you don´t have any rule denying the
traffic between the device and the remote...
You have a Cisco Unified Communications Manager (CUCM) system and want
to configure a SPA112 analog telephone adaptor (ATA) to register to the
CUCM so that you can use up to two analog phones or similar FXS devices
with the CUCM.In this application note, ...
Introduction: This document describes how to connect SG300 with Catalyst
switch via STP. Spanning Tree Protocol (STP) is a Layer 2 protocol that
runs on mainly on switches. The specification for STP is IEEE 802.1D.
The main purpose of STP is to ensure tha...