Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

SA520W - Can't change IPv4 settings

Hi,

I have updated a new SA520W to the newest firmware 2.1.71 and configured settings for LAN, WAN and WLAN.

Afterwards i configured two IPSec tunnels to two other Cisco SA500 devices.

Now i can't change any LAN IPv4 settings anymore.

When i click on the apply button, I only receive the information "LAN IP address is in the same subnet. Please specify IP address in a different subnet."

Why do i get this error message and how can i edit the IPv4 settings again?

Best regards,

Thomas

1 REPLY
New Member

SA520W - Can't change IPv4 settings

Do you have VLAN's set?

You may have to disable them first.

If you have VPN/IPSec settings....Delete the VPN policies first...change the IPSec policies, then re-create the VPN policies.  Awkward, but that's how it works. 

1189
Views
0
Helpful
1
Replies
CreatePlease to create content