Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

SA520W Optional WAN port problem

Hello,

 

I have a problem to configure the optional wan on my SA520W.

We have 2 connexions (Cable and ADSL), when I set the primary wan with the Cable there are no problems. When I set the primary wan with the ADSL there are no problems. But when I set the Cable on the primary wan, and the ADSL on the optional wan, primary wan works, but optional wan doesn't. Leds are green, link state is UP, but wan state is DOWN.

Connection Time: Not Yet Available
Connection Type: PPPOE
Connection State: Not Yet Connected
Link State: LINK UP
WAN State: DOWN
IP Address: 0.0.0.0
Subnet Mask: 0.0.0.0
Gateway: 0.0.0.0
DNS Server: 0.0.0.0
Secondary DNS: 0.0.0.0
MAC Address:

The SA520 runs firmware 2.2.07.

Can anyone point me to a solution ?

Thanks,

Graham.

Everyone's tags (1)
2 REPLIES
New Member

Can anyone help me with this?

Can anyone help me with this?  

Thanks.

Gold

Graham, To use both WAN ports

Graham,

 

To use both WAN ports at the same time, browse to Networking-> Optional Port-> WAN Mode. Select Load Balancing so that all traffic will be balanced between the two WAN ports. The other modes only allow a single WAN port to be connected at one time.

 

- Marty

64
Views
0
Helpful
2
Replies
CreatePlease login to create content