We replaced a Linksys RV082 using two external a ADSL modems by a SA540-K9, we advice a very poor load balancing and a lot of desconnections, p.e. when we are using FTP, the connection was disconnected, we need to try several times to download files, I update the device to 1.1.42 and made FTP protocol binding to only one WAN interface but the problem still, and the performance is very poor. If I return the RV082 the load balancing and FTP downloads works fine. We thought it would improve with the SA540, but the result is worse.
Hi every one!!!When you are configuring a remote VPN connection, there
are some steps that are lost on the path. Here you can see those steps.
A) In your Cisco device: 1. Ensure you don´t have any rule denying the
traffic between the device and the remote...
You have a Cisco Unified Communications Manager (CUCM) system and want
to configure a SPA112 analog telephone adaptor (ATA) to register to the
CUCM so that you can use up to two analog phones or similar FXS devices
with the CUCM.In this application note, ...
Introduction: This document describes how to connect SG300 with Catalyst
switch via STP. Spanning Tree Protocol (STP) is a Layer 2 protocol that
runs on mainly on switches. The specification for STP is IEEE 802.1D.
The main purpose of STP is to ensure tha...