Cisco Support Community
Community Member

Site to site VPN SA520W to ASA 5505


Have problem to configure site to site VPN to a ASA 5505.

Have a ASA 5505 installed on HQ as primary fw (static public IP) where also remote users can connect thru IP Sec VPN.

Now I have a site with shared Internet in that facility where I want to connect a SA520W with site to site VPN with a private DHCP adress.

Its ok if only the remote site can initiate connection.

Need config for both device.

SITE-A 192.168.10.X

SITE-B 192.168.11.X

Thank you.

Everyone's tags (5)
Community Member

Re: Site to site VPN SA520W to ASA 5505

Hello Mr Carlsson.
At this moment is not possible for us to send you the exact configuration that you would need to use for this particular case.
This because there are many variables that the you would need to set, according the company's policies and convenience.

To illustrate this point and help you with a guide, I send add a similar example of what you would need to do, If you take it on consideration and change the addresses and the settings for what you need, you will be able to configure your devices.
Remember that you need to set an static address on each point of the VPN, so is not possible to do it to a one that is assigned by DHCP.

Community Member

Re: Site to site VPN SA520W to ASA 5505


Thank you.

I Will test this as soon as possible.

Best regards//Fredrik

CreatePlease to create content