Re: Unsuccessful PPTP in between WRT54GL (dd-wrt v2.4) and Cisco
as you mentioned, the connection setup seems ok but then the WRT sends a TERMREQ and so the connection gets terminated. I gues you'll have to to check the logs on the WRT to find out why it is doing that (I have zero experience with dd-wrt so can't help you with that, but perhaps you can try in the forum which is dedicatd to Linksys/Cisco Small Business topics.
Having said that, I did spot something odd in the debugs, which may or may not be related:
Hi every one!!!When you are configuring a remote VPN connection, there
are some steps that are lost on the path. Here you can see those steps.
A) In your Cisco device: 1. Ensure you don´t have any rule denying the
traffic between the device and the remote...
You have a Cisco Unified Communications Manager (CUCM) system and want
to configure a SPA112 analog telephone adaptor (ATA) to register to the
CUCM so that you can use up to two analog phones or similar FXS devices
with the CUCM.In this application note, ...
Introduction: This document describes how to connect SG300 with Catalyst
switch via STP. Spanning Tree Protocol (STP) is a Layer 2 protocol that
runs on mainly on switches. The specification for STP is IEEE 802.1D.
The main purpose of STP is to ensure tha...