Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 

Debug and syslog Messages from SPA Analog Telephone Adaptors

** see the https://supportforums.cisco.com/docs/DOC-26697 document for SPA1xx ATA debug / syslog configuration **

In order to capture debug and syslog messages from your ATA, you need to have a syslog server on your network.

Here is a link to a document describing this.

Turn on debugging and syslog messaging as follows:

1. Determine the IP address of your syslog server

c:\ ipconfig /all  [Windows]

$ ifconfig -a  [UNIX]

For this example, assume a syslog server IP address of 192.168.0.200

2. Configure your ATA [SPA2102 in this example] by directing your browser to:

http://<IP_address_of_ATA>/admin/voice/advanced
Example: http://192.168.0.100/admin/voice/advancedif the ATA's IP address is 192.168.0.100

3. Edit the following fields:

a. ATA web-ui > Voice tab > System tab > Miscellaneous Settings > Syslog Server: <IP address of syslog server> Example: 192.168.0.200

b. ATA web-ui > Voice tab > System tab > Miscellaneous Settings > Debug Server: <IP address of syslog server> Example: 192.168.0.200

c. ATA web-ui > Voice tab > System tab > Miscellaneous Settings > Debug Level: 3

d. ATA web-ui > Voice tab > Line N > SIP Settings > SIP Debug Option: full

4. Scroll down and click Submit All Changes

The ATA will reboot and send all debug and syslog messages to the specified IP address of the syslog server.

[Don't forget to make sure that your syslog server is running and that its IP address is what you configured on the ATA]

<end>

11665
Views
4
Helpful
0
Comments