Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 

SPA1xx ATA Resync_At Parameter v1.2.1(004)

The SPA1xx ATA firmware introduced the Resync_At parameter in firmware version 1.2.1(004).

This new parameter can affect three SPA1xx ATA settings after a firmware upgrade unless you explicitly

configure these parameters.

These setting do not affect device stability or security in any way.

The affected parameters are:

  • Resync_At__HHmm_
  • Resync_At_Random_Delay
  • Resync_Fails_On_FNF

Eliminate unintended settings by configuring the parameters via a provisioning file or the web‐user

interface as described in the PDF document.

Note: If you factory reset the SPA1xx ATA after upgrading to 1.2.1(004), then the parameters are

correctly set and the above can be ignored.

<end>

Comments
New Member

How do I gain access to release v1.2.1(004)? All I see in the downloads section is 1.1.x based releases. Thanks.

Cisco Employee

Hi Chad,

It's available from

http://www.cisco.com/en/US/products/ps11978/index.html on the right side.

Here's a direct link:

http://www.cisco.com/cisco/pub/software/portal/select.html?&i=!m&mdfid=283998793

Regards,

Patrick

-----------

929
Views
0
Helpful
2
Comments