Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 

SPA2102 / SPA3102: Saving a Device's Configuration

Ever wonder how you can send your device's configuration to someone for analysis?

It's simple and is done in a few seconds.

You'll need:

  - Device's IP address

  - Computer with network access  to the device

  - Administration password for device [if set]

  - WAN access to the device's administration web server

Enabling WAN access to the Device:

  1. Connect an analog telephone to the PHONE 1 port of the device.

  2. Pick up the handset and press

  3. **** (in other words, press the star key four times). [You may not hear dial tone]

  4. After the greeting plays, determine the device's IP address by dialing 110#

  5. Enable WAN access to the device's web server by dialing

a. 7932#

b. 1# to enable

c. 1 to save

  5.  Hang up the handset

Save the configuration of the device as follows:

There are two distinct sections that must be saved separately, namely a Routing tab and a Voice tab.

A. Saving the Routing/Networking configuration of a device:

1. Direct your browser to http://<IP_of_device>/admin/advanced

2. Use your browser's save page feature to write the device's entire Router configuration to a single file:

      • IE: Page > Save As > Save as type Webpage, HTML only
      • FireFox: File > Save Page As > Save as type Web Page, complete

3. Name the file as follows: SPA-Router_date_time.html

Example: SPA-Router_Sep022009_09h18.html

B. Saving the Voice configuration of a device:

1. Direct your browser to http://<IP_of_device>/admin/voice/advanced

2. Use your browser's save page feature to write the device's entire Voice configuration to a single file:

      • IE: Page > Save As > Save as type Webpage, HTML only
      • FireFox: File > Save Page As > Save as type Web Page, complete

3. Name the file as follows: SPA-Voice_date_time.html

Example: SPA-Voice_Sep022009_09h18.html

Now you can send the HTML configuration files to someone in order to show them how you have configured the device. Don't worry, they cannot access your device's passwords.

Enjoy!

<end>

Version history
Revision #:
1 of 1
Last update:
‎03-23-2009 08:15 AM
Updated by:
 
Labels (1)
Comments
New Member

NOTE: Cisco have released a new version of SPA3102 firmware (version: 5.2.13)

This includes support for generating XML config by using the following URL: http://ip_addr/admin/config.xml