Issues with the Wireless setup of the WVC210 camera
I recently purchased the WVC210 Wireless camera. I have an SMC router (model #SMC8014WG). I am able to get it up and working on the Ethernet connection. I entered in the SSID and WEP for my local network as the instructions said and then power cycled the camera with the Ethernet cable disconnected. The Wireless led on the camera lit up to show that it was connected on the wireless. However, when I go to the URL to view the camera stream (the IP address that showed the camera strean via the Ethernet connection), it doesn't come up. Do I need to go to a different IP/URL to view the stream on the wireless? How do I find out which IP address is being used?
Cisco has a great solution for Video Surveillance including IP Cameras
and Network Storage Servers. A FAQ is how much bandwidth and disk space
is required to operate Video Surveillance. The answer is 'it depends'.
Depends on Resolution, frame rate, image ...
I have 2 WVC210 cameras. I took them temporarily off line while
performing building maintenance. Now one of them will not lock on the
wireless signal regardless of it's proximity to the router (2 feet, 10
feet, etc.). It does function correctly when wired...
I used to have a Lynksys N160 router and one day it died suddenly. I
replaced it with a N750 EA3500 router and finally figured out how to do
all the pass through things I needed to do and can now see the camera
while it is connected via eathernet wired. I...