Re: Problems using Cisco Video Monitoring System on W2003
I would try the following : In SWVMS16 go to Setup-> Setting-> Camera Tab. Search for your camera and enter the Username and Password that you set in the web UI of the camera. The default is admin/admin. Usually the reason that the video works in the web UI and not in the software is for lack of authentication. If you need further assistance please call Small Business Support at 1-866-606-1866.
Hi every one!!!When you are configuring a remote VPN connection, there
are some steps that are lost on the path. Here you can see those steps.
A) In your Cisco device: 1. Ensure you don´t have any rule denying the
traffic between the device and the remote...
You have a Cisco Unified Communications Manager (CUCM) system and want
to configure a SPA112 analog telephone adaptor (ATA) to register to the
CUCM so that you can use up to two analog phones or similar FXS devices
with the CUCM.In this application note, ...
Introduction: This document describes how to connect SG300 with Catalyst
switch via STP. Spanning Tree Protocol (STP) is a Layer 2 protocol that
runs on mainly on switches. The specification for STP is IEEE 802.1D.
The main purpose of STP is to ensure tha...