I recently purchased a Cisco PVC2300 ethernet camera. I am trying to use it in a very specific and unorthodox manner. Ideally, I would like the camera to be constantly streaming the data packets over ethernet without any responses from other computers. This will not be used over the internet and security isn't an issue.
Thus, is there any way to set up the camera to just constantly stream video once it is turned on? In my environment, it cannot be dependent on receivng any packets from any other source.
If this product cannot do such a task, does Cisco have any products that can?
Hi every one!!!When you are configuring a remote VPN connection, there
are some steps that are lost on the path. Here you can see those steps.
A) In your Cisco device: 1. Ensure you don´t have any rule denying the
traffic between the device and the remote...
You have a Cisco Unified Communications Manager (CUCM) system and want
to configure a SPA112 analog telephone adaptor (ATA) to register to the
CUCM so that you can use up to two analog phones or similar FXS devices
with the CUCM.In this application note, ...
Introduction: This document describes how to connect SG300 with Catalyst
switch via STP. Spanning Tree Protocol (STP) is a Layer 2 protocol that
runs on mainly on switches. The specification for STP is IEEE 802.1D.
The main purpose of STP is to ensure tha...