Unable to record Audio from WVC210 built in microphone.
I have a WVC210v1 (Firmware V1.1.0) camera & SWVMS16 v18.104.22.16866 which I am using for monitoring a small room. In the Camera's Audio Settings web page I have enabled Audio "Simplex - Listen Only" and selected codec as G.711 A-Law. In the SWVMS16 main console I can see the Video Stream from the camera and also hear the audio. When I check the recording I am able to see the recording but don't hear any audio.
Can anybody suggest me how can I record the audio along with the video.
Hi every one!!!When you are configuring a remote VPN connection, there
are some steps that are lost on the path. Here you can see those steps.
A) In your Cisco device: 1. Ensure you don´t have any rule denying the
traffic between the device and the remote...
You have a Cisco Unified Communications Manager (CUCM) system and want
to configure a SPA112 analog telephone adaptor (ATA) to register to the
CUCM so that you can use up to two analog phones or similar FXS devices
with the CUCM.In this application note, ...
Introduction: This document describes how to connect SG300 with Catalyst
switch via STP. Spanning Tree Protocol (STP) is a Layer 2 protocol that
runs on mainly on switches. The specification for STP is IEEE 802.1D.
The main purpose of STP is to ensure tha...