I am reinstalling a WVC210 camera that is connected to the network. When i start the installation CD it finds the camera and then askes for password and username. After entering admin /admin as default it rejects as invalid. admin user and password was never changed underlast install.
Hi, My name is Eric Moyers. I am a Network Support Engineer in the Cisco Small Business Support Center. Thank you for using the Cisco Community Post Forums.
Was this a brand new purchase? Try holding the reset button on the bottom for about 20 to 35 seconds. This should reset it back to factory defaults. Then try to get in using the default username and password.
CONFIDENTIALITY NOTICE: This communication with its contents may contain confidential and/or legally privileged information. It is solely for the use of the intended recipient(s). Unauthorized interception, review, use or disclosure is prohibited and may violate applicable laws including the Electronic Communications Privacy Act. If you are not the intended recipient, please contact the sender and destroy all copies of the communication.
Network Deployment on PVC300 PTZ Internet Camera
The objective of this document is to explain the deployment setup of the PVC300 PTZ Internet Camera. There are two options for deploying the camera on the network. This artic...
Basic Setup Settings on the PVC2300 Internet Video Camera
In the Basic Setup section of the PVC2300 Internet Video Camera, any user can edit properties such as the camera name, description, time, and network settings.
Configure RTP and RTSP on PVC300 PTZ Internet Camera
Real-Time Protocol (RTP), is an Internet protocol for transmitting real-time data such as audio and video. RTP itself does not guarantee real-time delivery of data, but ...