I am new to this forum and I need some help installing my cisco wvc200 internet video camera.
Before I bought a new computer I had installed the camera on my laptop which had windows xp. It worked fine when I used a wireless connection.
Now I have bought a new computer which has windows 7 on it. The camera won't connect wireless. It works fine using a cabled connection but when I try wireless it won't work. I use the set-up from the cd-rom. When I type the ip-adress in internet explorer with the cable-connection I can connect to the camera. I follow the instructions from the set-up and the manual I got with it. After executed all the steps I'm trying to connect it wireless. When I type the adress without the cable, internet explorer says it cannot find the page. What am I doing wrong?
2. I thought it had an IP address from the router.
3. It works when I installed the camera with the setup cd in my computer (windows 7) and the camera plugged in the router. When I unplug the camera after following the instructions I don't get a wireless connection.
4. This was all done by the setup and it seemed to be correct.
Hi every one!!!When you are configuring a remote VPN connection, there
are some steps that are lost on the path. Here you can see those steps.
A) In your Cisco device: 1. Ensure you don´t have any rule denying the
traffic between the device and the remote...
You have a Cisco Unified Communications Manager (CUCM) system and want
to configure a SPA112 analog telephone adaptor (ATA) to register to the
CUCM so that you can use up to two analog phones or similar FXS devices
with the CUCM.In this application note, ...
Introduction: This document describes how to connect SG300 with Catalyst
switch via STP. Spanning Tree Protocol (STP) is a Layer 2 protocol that
runs on mainly on switches. The specification for STP is IEEE 802.1D.
The main purpose of STP is to ensure tha...