Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

WVC210 and WPA-enterprise

I bought a WVC210 and want to configure it with WPA Enterprise. Regarding to http://www.cisco.com/en/US/prod/collateral/vpndevc/ps6918/ps9692/ps9944/ps9948/data_sheet_c78-504108.pdf it should be an option, but it isn't in the admin config pages. I've tried updating the firmware (1.0.0).

Why doesn't it work? Any help is appricated

:)

Everyone's tags (4)
9 REPLIES

Re: WVC210 and WPA-enterprise

I have a WVC210 running FW 1.1.0 and it has this option...

WVC210_WPA.GIF

New Member

Re: WVC210 and WPA-enterprise

Ok, but where do I find firmware 1.1.0? :)

Re: WVC210 and WPA-enterprise

That is an excellent question.

here is where I always look, and I dont see it there.....

http://www.cisco.com/cisco/psn/web/solutions/small_business/products/firmware.html

Am asking inside....

Steve D

SE US Field Channel

Re: WVC210 and WPA-enterprise

I just spoke to Engineering Project Management.  Its very close to being approved and will be posted at that site I referenced.

Please check back periodically, I have no ETA to share.

(The approval pending is an internal Legal review of open source included in the firmware and this usually shouldnt take more than a week or 2)

Steve

New Member

Re: WVC210 and WPA-enterprise

OK, thanks! Hopefully you will release it soon!

Do you know if the WPA Enterprise supports certificates?

Re: WVC210 and WPA-enterprise

Yes, it supports Root and User CA and has an upload button.

New Member

Re: WVC210 and WPA-enterprise

Thats great! Hopefully it comes soon then! Thank you for your help! Very good  :)

Re: WVC210 and WPA-enterprise

Thanks for your patience.   I monitor these communities and will do my best to keep you informed.

New Member

Re: WVC210 and WPA-enterprise

Hi!

The firmware is now out and I have the options in the web interface! But, I can't get it to work. We have Cisco Aironet APs with WAP-EAP against a MS IAS (via RADIUS) with certificates configured. I've tried to upload the certificate to the cam but it doesn't work. The webinterface doesn't offer much help. Is there any guide or something like that?

Thank you!

Andreas

1964
Views
0
Helpful
9
Replies
CreatePlease to create content