I updated my WVC210 firmware from 1.0.0 to 1.1.0 and now I have two big problems.
With 1.0.0 I used to let the camera ON (always, 24 hrs a day), and I used to shut down my router during the night.
In the morning I used to set to ON the router and the WVC210 (wireless connected) automatically linked to the router and to DynDNS (so that I was able to reach the camera both from my LAN and from the internet).
1. Now with 1.1.0 the WVC210 (always ON) doesn't automatically connect to the wireless when I restart my router: I always need to start the router first and then to restart the camera;
2. the DynDNS doesn't update automatically as before happened (I need to do as describet on point 1. ...router first, then webcam).
Hi every one!!!When you are configuring a remote VPN connection, there
are some steps that are lost on the path. Here you can see those steps.
A) In your Cisco device: 1. Ensure you don´t have any rule denying the
traffic between the device and the remote...
You have a Cisco Unified Communications Manager (CUCM) system and want
to configure a SPA112 analog telephone adaptor (ATA) to register to the
CUCM so that you can use up to two analog phones or similar FXS devices
with the CUCM.In this application note, ...
Introduction: This document describes how to connect SG300 with Catalyst
switch via STP. Spanning Tree Protocol (STP) is a Layer 2 protocol that
runs on mainly on switches. The specification for STP is IEEE 802.1D.
The main purpose of STP is to ensure tha...