WVC210 monitoring software "Missing or corrupted resource files. Please re-install the system to solve the problem."
The software is being installed on Windows 7. I tried running the installer as administrator on setup. I also made sure the program settings were Windows XP SP2 and run as administrator. Is there some other way to have it run?
Re: WVC210 monitoring software "Missing or corrupted resource fi
This issue is usually related to attempting to load the software on a netbook that does not support the minimum required screen resolution. I have seen the software load with a resolution of 1024x768, but never less than that.
Hi every one!!!When you are configuring a remote VPN connection, there
are some steps that are lost on the path. Here you can see those steps.
A) In your Cisco device: 1. Ensure you don´t have any rule denying the
traffic between the device and the remote...
You have a Cisco Unified Communications Manager (CUCM) system and want
to configure a SPA112 analog telephone adaptor (ATA) to register to the
CUCM so that you can use up to two analog phones or similar FXS devices
with the CUCM.In this application note, ...
Introduction: This document describes how to connect SG300 with Catalyst
switch via STP. Spanning Tree Protocol (STP) is a Layer 2 protocol that
runs on mainly on switches. The specification for STP is IEEE 802.1D.
The main purpose of STP is to ensure tha...