Any know how to set this cam up for 2 way audio? I have Full Duplex - Talk and Listen (can be Simultaneously) selected. I then hooked up speakers to the speaker jack but I i hear is myself. The person on the other end logged into my cam I cant hear them. It says 2 way audio so I assumed that means I can talk and they can talk and we hear each other.
2-way audio should work with the camera and the computer running the browser being able to talk to each other. Can the person sitting in front of the computer hear you? I'm assuming there is a MIC connected on the computer for the other person to talk to the camera with.
If you would like someone to walk you through this please contact Small Business Support at 866.606.1866
Yes, that is possible. Make sure the remote browser is Internet Explorer and the Active-X script needs to be allowed to run for 2-way audio. Contact the support center if you need help in setting this up.
Hi every one!!!When you are configuring a remote VPN connection, there
are some steps that are lost on the path. Here you can see those steps.
A) In your Cisco device: 1. Ensure you don´t have any rule denying the
traffic between the device and the remote...
You have a Cisco Unified Communications Manager (CUCM) system and want
to configure a SPA112 analog telephone adaptor (ATA) to register to the
CUCM so that you can use up to two analog phones or similar FXS devices
with the CUCM.In this application note, ...
Introduction: This document describes how to connect SG300 with Catalyst
switch via STP. Spanning Tree Protocol (STP) is a Layer 2 protocol that
runs on mainly on switches. The specification for STP is IEEE 802.1D.
The main purpose of STP is to ensure tha...