Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

WVC210 with Motion Detection does not stay in the correct position

When I set the camera in a specific position (setting it as Home) and then I enable Motion Detection feature (setting area and sensibility using the home position); if i have set the "Disable Motion Detection while position is incorrect" with "Go to Motion Detection position if idle" option the camera will reset the tilt after the time set has expired.

Is it a known bug (I have not found anything about that here)?

Is there a way to set which is the motion detection position to be held?

Everyone's tags (3)
1 ACCEPTED SOLUTION

Accepted Solutions

Re: WVC210 with Motion Detection does not stay in the correct po

Yep,  It's "hot off the press".

Ok,  at the moment you have to log into cisco to get that file.

wvc210.JPG

8 REPLIES

Re: WVC210 with Motion Detection does not stay in the correct po

Hi M.Bordoni,

I will pass this onto the wonderful folks at the Small Business Support Center to get their opinion.

Just out of interest, I'm guessing you are utilities built within the camera to send a image somewhere ?

Are you  using the  free Surveillance monitoring application to store captured video on your NAS/PC or server ?

regards Dave

New Member

Re: WVC210 with Motion Detection does not stay in the correct po

I'm uploading images to an internal FTP server on a server, then I can watch them using a website.

regards

Michele

Silver

Re: WVC210 with Motion Detection does not stay in the correct po

As far as I know, this is not a known issue.  If you could, call in to the SBSC at 866-606-1866 and let them troubleshoot with you on the issue.  Are you running the latest version of firmware the 1.2.0 version.  If not upgrade that and test your configuration out and see if that resolves the issue.  If that does not fix it.  Give the SBSC a call and let them troubleshoot it with you.

New Member

Re: WVC210 with Motion Detection does not stay in the correct po

As far as I know the latest version for WVC210 is 1.0.0 where can I find the 1.2.0 version?

I have some problem to have a chat with you since I am in Italy now.

I looked for a new version of the firmware on the support site and I have found the 1.0.0 version only.

Please let me know where can I find it.

Regards

Michele

New Member

Re: WVC210 with Motion Detection does not stay in the correct po

You can find the latest firmware on cisco.com web cite under downloads for WVC210. The latest firmware version is 1.1.0.12

Re: WVC210 with Motion Detection does not stay in the correct po

Yep,  It's "hot off the press".

Ok,  at the moment you have to log into cisco to get that file.

wvc210.JPG

New Member

Re: WVC210 with Motion Detection does not stay in the correct po

Camera Upgraded, i will check if it fixes the issues and i will let you know.

Thanks

Michele Bordoni

New Member

Re: WVC210 with Motion Detection does not stay in the correct po

Thank you very much, with the new firmware everything runs smoothly.

The issue has been fixed.

Take care that I found some links that still point to the original software (1.0.0)

Regards

Michele Bordoni

1943
Views
0
Helpful
8
Replies
CreatePlease login to create content