I have a standalone 1142 AP. It is connected to a Cisco ESW switch. For the guest wireless network, I put VLAN 12 on the AP with open authentication. I added vlan 12 to the switch. I added vlan 12 to the port the AP is plugged into and the port that is plugged into the router. The router port is the dmz port for guest wireless access. I changed the switch port to general. The pvid is 12 with vlan 1 excluded. The switch port with the AP is setup as a trunk port.
It can see the guess network but I cannot connect to it. If I plug my laptop into the DMZ port on the router, I can get on the internet. The router is serving DHCP to the guest wireless clients. If I try to statically assign an IP to my wireless client, I still do not get internet access.
The corporate wireless works with no problems on vlan 1.
Hi every one!!!When you are configuring a remote VPN connection, there
are some steps that are lost on the path. Here you can see those steps.
A) In your Cisco device: 1. Ensure you don´t have any rule denying the
traffic between the device and the remote...
You have a Cisco Unified Communications Manager (CUCM) system and want
to configure a SPA112 analog telephone adaptor (ATA) to register to the
CUCM so that you can use up to two analog phones or similar FXS devices
with the CUCM.In this application note, ...
Introduction: This document describes how to connect SG300 with Catalyst
switch via STP. Spanning Tree Protocol (STP) is a Layer 2 protocol that
runs on mainly on switches. The specification for STP is IEEE 802.1D.
The main purpose of STP is to ensure tha...