Hi Vijay, a transparent mode firewall is essentially a layer 2 switch function. Keeping to the fundamentals, a layer 2 forwarding device doesn't particularly care about layer 3 IP addresses. On a transparent ASA, it does look up based on MAC, not by IP except under a very few certain conditions.
-Tom Please mark answered for helpful posts
Please mark answered for helpful posts
Sx550X, Sx350X, Sx250: PSE will Supply Power to Catalyst PSE Ports
May 31, 2016
June 5, 2017
Configure Remote Network Monitoring (RMON) Events Control Settings on a Switch through the Command Line Interface (CLI)
Remote Network Monitoring (RMON) was developed by the Internet Engineering Task Force (IETF) to support...