Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

2960 to SG200

I am trying to leverage a couple of SG200 for a small office area.    It will be downstream from a 2960 layer 2 switch, connected to a trunk enabled port on the 2960.  

The topology looks like this:

/PC DESKTOP/====/IPPHONE (7962)/======/SG200/======/2960/

I need VLANs 1,5,and 50 to be allowed to the

The uplink port on 2960 has the following configured:

interface GigabitEthernet1/0/7

description WALL JACK D10 - Spare Desk

switchport trunk allowed vlan 1,10,50

switchport mode trunk

priority-queue out

mls qos trust cos

spanning-tree portfast trunk

!

The uplink port on the SG200 is configured as a TRUNK, allowing all VLANS.   The client port G1 is with VLAN 1 Untagged and VLAN50 tagged.   But the phone doesn't appear to be configured in the correct VLAN (which is 50 for voice).

Guidance would be welcome,

John

Everyone's tags (6)
1 REPLY
New Member

2960 to SG200

Hi brunellej, thank you for using our forum, my name is Luis I am part of the Small business Support community.

I have a couple of questions for you, are you using VTP in the 2960 switch? Could you please tell us, if this configuration that you put in your post is a configuration from the SG200? If not, could you add it?

Thank you!

Greetings,

Luis Arias.

Cisco Network Support Engineer.

353
Views
0
Helpful
1
Replies
CreatePlease to create content