We have 3 SLM2048 Switches. We have a multi office site and have recently been moving these offices around. When the computers are patched in to their new locaitons we are get some computers with "Limited or no connectivity". Although the computers prior are on the same cabling. The switches only do this when moving computers from one place to another. The fix i have found so far is to move the computers in question onto one of the other switches where they pick up an IP address and connect normally.
Introduction:Topology Diagram:Configuration Overview:Related
Information: Introduction: This document describes how to connect SG300
with Catalyst switch via STP. Spanning Tree Protocol (STP) is a Layer 2
protocol that runs on mainly on switches. The spec...
Recently, HP Networking published a blog post attempting to counter the
favorable third party Miercom report on our Cisco® 200 and 300 Series
Smart and Managed switches:
The Sx500 Series Stackable Switches offers different port features. You
can add security to a port, make the port more energy efficient, map a
VLAN to a port, make a port available or not to a specific network
portion, and so forth. The next set of articl...