300 or 500 Series VLAN Mapping/Translation Feature?
As far as I can tell, there's no way to do VLAN mapping/translation in the 300 or 500 series switches like you can do in some Catalyst platforms. Considering that you can set a VLAN based on EtherType, MAC address/OUI is it feasible that setting the VLAN ID based on the existing VLAN ID might work its way into the feature list in the near future? What's in place already is effectively pushing and popping VLAN tags on and off frames on egress/ingress - what I'd like is a 'swap' function.
I appreciate that this is commonly used in Metro Ethernet deployments but the same applies to QinQ which is also a feature in both the 300 and 500 series units. Is there anyone here with any insight into the product roadmap that might be able to give us some further info? Is there an official way to submit a feature request for the Small Business Series products?
Article ID:4006 Configure Secure Shell (SSH) Server Authentication
Settings on a Switch Objective Secure Shell (SSH) is a protocol that
provides a secure remote connection to specific network devices. This
connection provides functionality that is similar...
Article ID:4982 Access an SMB Switch CLI using SSH or Telnet Objective
The Cisco Small Business Managed Switches can be remotely accessed and
configured through the Command Line Interface (CLI). Accessing the CLI
allows commands to be entered in a termina...
Article ID:5735 Convert Configuration Files using the Configuration
Migration Tool on Cisco Small Business Switches Introduction The Cisco
Configuration Migration Tool allows you to convert configuration files
from previous generation of Cisco Small Busin...