appropriate procedure to export and import switch configurations??
We have several SFP-300 series PoE switches already configured and in production usage.
What is the appropriate procedure to export the configuration from one of these switches, then import into a newly-purchased switch of the same model??
The only thing that needs to be different asap is the switch's IP address...can I modify this within the exported configuration file to be imported?? Or is there some other way I should go about this process??
The configuration is just a text file. It's contents is basically just a list of configuration commands. You can download a backup from one of the switches that are already in use and modify it in a text editor. Then, you should be able to upload it to the new switch. That probably just works without adjustments, if the new switch has the same interface type and count.
Introduction:Topology Diagram:Configuration Overview:Related
Information: Introduction: This document describes how to connect SG300
with Catalyst switch via STP. Spanning Tree Protocol (STP) is a Layer 2
protocol that runs on mainly on switches. The spec...
The Sx500 Series Stackable Switches offers different port features. You
can add security to a port, make the port more energy efficient, map a
VLAN to a port, make a port available or not to a specific network
portion, and so forth. The next set of articl...
Recently, HP Networking published a blog post attempting to counter the
favorable third party Miercom report on our Cisco® 200 and 300 Series
Smart and Managed switches: