on 10-18-2011 03:26 AM
Hello,
I just got SG200-26, is it possible to assign 10 static IP to say, port 2? If i can, please help with step? I greatly appreciated and big THANKS in advance.
No - you can't assign ip address to ports on an SG200 (switch). Normally when you assign ip address to ports, this is on a layer3 device/router.
Hope this helps,
Jasbryan
Thanks Jasbryan for cleared this up for me. Can you point out a few device/router that can do this job? I would like to have the ones with web interface. also, it can be by cisco or other company. Again, I thank you.
Ben,
Can you explain to me what you are trying to accomplish so i could suggested the correct router/layer 3 device for you.
Thanks,
Jasbryan
Hello,
I'm trying to setup a dedicated server hosting. There is an GigE with /24 IPs coming into my switch/router, I"m trying to distribute these IPs to each server, each server would have 5 or 10 IPs ect. Thanks
So you're trying to dedicate a (5 or 10) range of public ip address to one server?
Yes, that's correct.
Ben,
The small business line routers/switch isn’t going to allow what you need.
Yeah you will need to move up to the enterprise small business products
http://www.cisco.com/en/US/products/ps10906/Products_Sub_Category_Home.html
Enterprise pre-sales number
303-309-9852
You’re probably looking at ASA5505- Cisco800 series or even maybe 1900 series. Please look up spec’s and call the presales line for best choice.
ASA5500
Cisco 800
http://www.cisco.com/en/US/products/hw/routers/ps380/products_data_sheets_list.html
Cisco 1900
http://www.cisco.com/en/US/products/ps10538/products_data_sheets_list.html
Hope this helps,
Jasbryan
Thank you for all your help.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: