I am using around 5 sg300's with a lot of Crestron AV kit / touchscreens. About once every couple of months the touchscreens all stop responding. We have found that a reboot of the Cisco switch attached to the touchscreens brings everything back to life. This has happened more than once. It will be pretty impossible to find out what is actually causing the issue but i was wondering if there is a way to get the switches to reboot every Sunday night (say) to try and avoid this in the future. No ideal I know but better than nothing.
If i may ask - was your answer a generic one (make sure you have the latest firmware etc.) or did you recognise something in my symptoms that was fixed between 188.8.131.52 and 184.108.40.206 ? I tried looking at the release notes for the firmware but it was not obvious what had changed.
Article ID:4006 Configure Secure Shell (SSH) Server Authentication
Settings on a Switch Objective Secure Shell (SSH) is a protocol that
provides a secure remote connection to specific network devices. This
connection provides functionality that is similar...
Article ID:4982 Access an SMB Switch CLI using SSH or Telnet Objective
The Cisco Small Business Managed Switches can be remotely accessed and
configured through the Command Line Interface (CLI). Accessing the CLI
allows commands to be entered in a termina...
Article ID:5735 Convert Configuration Files using the Configuration
Migration Tool on Cisco Small Business Switches Introduction The Cisco
Configuration Migration Tool allows you to convert configuration files
from previous generation of Cisco Small Busin...