AUTOSMARTPORT-F-DEV_CALC_FAILED: XDP device type calculation failed: interface
The company I work for has some Cisco hardware in the plant and, as our team has no expertise on configuring Cisco switches I hope you can help me and my team to get this problem solved. I will make a brief comment on what is going wrong here:
I own two SG300-28 and they are connected using LAG over 2 interfaces (GI27 and GI28) but this is not the problem, I think, just the scenario. So I have two sides:
CSC <--- LAG ---> TOO
At CSC I have no problem and the switch is running fine for 38 days (we had a hard reboot back there).
On the other hand, at TOO, we are facing a soft reboot problem and we are not able to fix it. The only message we got, just before the reboot is:
And the switch reboots. This is causing us a lot of problems. As an emergency exit (and it's not fully working) we disabled AutoSmartPort (which is a functionality we will never use in the network layout so we don't need it).
Is there anything you can tell me to do? I am attaching running config for TOO. Befero someone ask we already tried to change the hardware (we own a spare SG300) and the same problem is there.
Article ID:4006 Configure Secure Shell (SSH) Server Authentication
Settings on a Switch Objective Secure Shell (SSH) is a protocol that
provides a secure remote connection to specific network devices. This
connection provides functionality that is similar...
Article ID:4982 Access an SMB Switch CLI using SSH or Telnet Objective
The Cisco Small Business Managed Switches can be remotely accessed and
configured through the Command Line Interface (CLI). Accessing the CLI
allows commands to be entered in a termina...
Article ID:5735 Convert Configuration Files using the Configuration
Migration Tool on Cisco Small Business Switches Introduction The Cisco
Configuration Migration Tool allows you to convert configuration files
from previous generation of Cisco Small Busin...