Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Boot image upgrade for SG300-28P

Hi,

I have an SG300-28P and I need to upgrade both the boot & firrmware versions.

The problem is I can't find the boot file anywhere, the only file available on the Cisco downloads page is the firmware file ('.ros')

These are my current versions:

show ver

SW version    1.3.5.58 ( date  10-Oct-2013 time  17:15:41 )

Boot version    1.0.0.4 ( date  08-Apr-2010 time  16:37:57 )

HW version    V01

And I get this warning at boot...

***********************************************************

***********************************************************

** Boot version is incompatible with the system image.   **

** Some new features have been disabled.                 **

** Please update to newest boot version.                 **

***********************************************************

***********************************************************

Hence the need to upgrade.

Cheers Ian

1 ACCEPTED SOLUTION

Accepted Solutions
Gold

Boot image upgrade for SG300-28P

ian-heath,

When you download:

Sx300 Firmware Version 1.3.5.58

Sx300_FW_Boot_1.3.5.58.zip

The zip file ha a copy of the firmware and also a copy of the boot code. The boot code needs to be upgraded via tftp server. After the boot code is upgraded, download and install the latest firmware Release 1.3.7.18. (No boot code with this one)

- Marty

2 REPLIES
Gold

Boot image upgrade for SG300-28P

ian-heath,

When you download:

Sx300 Firmware Version 1.3.5.58

Sx300_FW_Boot_1.3.5.58.zip

The zip file ha a copy of the firmware and also a copy of the boot code. The boot code needs to be upgraded via tftp server. After the boot code is upgraded, download and install the latest firmware Release 1.3.7.18. (No boot code with this one)

- Marty

New Member

Boot image upgrade for SG300-28P

Hi Marty,

Many thanks, I was looking at the latest FW version (I didn't realise that I needed that specific version/ZIP to get the boot code :-)

Cheers Ian

721
Views
0
Helpful
2
Replies