Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

booting with mode CLI and not with the console.

hi,

On a SF300-08, is anybody knows how to work with CLI and not with the Console Menu Interface ?

Thank you for your help.

Pascal Linglin

4 REPLIES

Re: booting with mode CLI and not with the console.

Hi Pascal.

Firstly make sure your switch is using the most recent firmware, which is now as of yesterday  1.1.2.0 .

When that firmware is running on the switch,  a textview CLI option should be seen on the main menu as per the following screen capture;

to get back to the menu, just type menu from the cli interface.

Hope i answered your question?


regards Dave

New Member

booting with mode CLI and not with the console.

Hi David,

Thank you for your answer,

is it possible to change value of register to boot in mode CLI and not with that main menu ?

I don't know where to find documentation about that.

kind regards.

Pascal.

Re: booting with mode CLI and not with the console.

Hi Pascal,

When I used telnet to get to the switch, it dropped me in a command line and NOT a menu.

I had to type "menu" from the command line to get to the menu  that you can see in my previous posting.

So it's there now. :-)

regards Dave

New Member

Re: booting with mode CLI and not with the console.

Thank you very much for your help.

Pascal.

dhornste a écrit :

David Hornstein

created the discussion

"Re: booting with mode CLI and not with the console."

To view the discussion, visit:

https://supportforums.cisco.com/message/3503182#3503182

889
Views
0
Helpful
4
Replies
CreatePlease to create content