Can SF300 switch handle 2 or more VOICE VALANs once and how to set up it to work with 2 VOICE VLANs?
We would like to set up a SF300 48 ports switch (we have a few of them) to work with 2 VOICE VLANs (VOICE VLAN 40 for one type of Cisco IP telefons and VOICE VLAN 42 for another type of Cisco IP telefons) but with command Voice Vlan ID 40 or Voice Vlan ID 42 we could only make just one of them to work at a time that is both is not working once. My question is:
- can SF300 switch handle 2 or more VOICE VALANs once?
Hi every one!!!When you are configuring a remote VPN connection, there
are some steps that are lost on the path. Here you can see those steps.
A) In your Cisco device: 1. Ensure you don´t have any rule denying the
traffic between the device and the remote...
You have a Cisco Unified Communications Manager (CUCM) system and want
to configure a SPA112 analog telephone adaptor (ATA) to register to the
CUCM so that you can use up to two analog phones or similar FXS devices
with the CUCM.In this application note, ...
Introduction: This document describes how to connect SG300 with Catalyst
switch via STP. Spanning Tree Protocol (STP) is a Layer 2 protocol that
runs on mainly on switches. The specification for STP is IEEE 802.1D.
The main purpose of STP is to ensure tha...