Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Can't define PVE Uplink with srw224g4

Hi,

I tried to  setup sample usage of PVE with Linksys  SRW224G4 withot success. I successfully set PVE g1 for ports 1 to 5 but I can't setup uplink port for this PVE group. I can't find place where can define PVE mapping an PVE upllink in web view. When I googled about this  I find that in "Port config" section in firmware version befor 1.2.2 have "pve mapping", but there is not such link. How can i define Uplink for particular PVE group in firmware version before 1.2.2?

Thanks in advance

1 REPLY

Re: Can't define PVE Uplink with srw224g4

Huh,

Even though i am using older software here, it seems straight forward.

Can I humbly suggest, that you contact the SBSC  to get some phone help, if this switch is still under phone support warranty.

http://www.cisco.com/en/US/support/tsd_cisco_small_business_support_center_contacts.html

regards Dave

788
Views
0
Helpful
1
Replies
CreatePlease to create content