03-03-2014 09:58 PM
Hi guys,
I am looking at buying 2x SG500-48 switches with the stacking cables and connecting them into a ring stack topology.
my reason for wanting this is so we can setup LACP connections from our hyper-v servers to the 2 stacked switches so the we have a redundant connection to the network if one of the switches is to fail. can you setup LACP links on the stacked SG-500 switches to be in the same group/link?
Solved! Go to Solution.
03-04-2014 03:23 AM
Sure can
-Tom
Please mark answered for helpful posts
http://blogs.cisco.com/smallbusiness/
03-04-2014 09:44 AM
Damon,
I think that you will find the following thread helpful:
https://supportforums.cisco.com/message/3832040
- Marty
03-04-2014 09:47 AM
Hello Damon,
The following link shows the step-by-step instructions to configure LACP ling aggregation on Sx500 switches.
Hope this helps.
Nagaraja
03-04-2014 03:23 AM
Sure can
-Tom
Please mark answered for helpful posts
http://blogs.cisco.com/smallbusiness/
03-04-2014 09:44 AM
Damon,
I think that you will find the following thread helpful:
https://supportforums.cisco.com/message/3832040
- Marty
03-04-2014 09:47 AM
Hello Damon,
The following link shows the step-by-step instructions to configure LACP ling aggregation on Sx500 switches.
Hope this helps.
Nagaraja
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: