hI all a very simple configurations ... bought 10 smb sg-300 28mp switches . every thing goes fine in vlan configuration, port assigning .. but when I try to assign ip to one of the created vlan interface switch hangs GUI or CLI. Layer 3 is enabled. regards
One thing to keep in mind when setting up these switches is this. Whatever address you first statically set on the switch will become it's management address. As soon as you enter an IP for a VLAN interface it will remove the default address of 192.168.1.254. Try setting one address and then accessing the switch at the address you just set. I'm assuming your are telnet/SSHing in, you can also try the console cable so that when that IP address changes you will still have access to the CLI.
Hope that helps,
Christopher Ebert - Advanced Network Support Engineer
Article ID:4006 Configure Secure Shell (SSH) Server Authentication
Settings on a Switch Objective Secure Shell (SSH) is a protocol that
provides a secure remote connection to specific network devices. This
connection provides functionality that is similar...
Article ID:4982 Access an SMB Switch CLI using SSH or Telnet Objective
The Cisco Small Business Managed Switches can be remotely accessed and
configured through the Command Line Interface (CLI). Accessing the CLI
allows commands to be entered in a termina...
Article ID:5735 Convert Configuration Files using the Configuration
Migration Tool on Cisco Small Business Switches Introduction The Cisco
Configuration Migration Tool allows you to convert configuration files
from previous generation of Cisco Small Busin...