cannot assign static ip address to lag, cisco switch sf300
Hi Tri.the reason you cannot assign an IP to VLAN or LAG is because the switch is in layer 2 mode. First you need to configure the switch in layer 3 mode. This will erase the configuration off the switch. Once that is done, make sure to assign a static IP address to VLAN 1 then you may create additional VLAN and assign IP address to them.
-Tom Please mark answered for helpful posts
Please mark answered for helpful posts
Article ID:4006 Configure Secure Shell (SSH) Server Authentication
Settings on a Switch Objective Secure Shell (SSH) is a protocol that
provides a secure remote connection to specific network devices. This
connection provides functionality that is similar...
Article ID:4982 Access an SMB Switch CLI using SSH or Telnet Objective
The Cisco Small Business Managed Switches can be remotely accessed and
configured through the Command Line Interface (CLI). Accessing the CLI
allows commands to be entered in a termina...
Article ID:5735 Convert Configuration Files using the Configuration
Migration Tool on Cisco Small Business Switches Introduction The Cisco
Configuration Migration Tool allows you to convert configuration files
from previous generation of Cisco Small Busin...