Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Cannot login to sg200-26 after factory reset.

After a factory reset I can no longer log in to the switch.  This reset appeared to work, as the switch's IP changed back to factory default, and I can bring up the web interface there.  It refuses to permit logins using either the old user/password combo or the default cisco/cisco combo.  Any ideas?

  • Small Business Switches
2 REPLIES

Hi , After your factory reset

Hi ,

 After your factory reset , have you got assigned with IP address from 192.168.1.x segment , and you should reach the switch using 192.168.1.254 IP address . 

Try reset-ing again and try with default username cisco and password cisco

HTH

Sandy

 

New Member

I appreciate the help.  I am

I appreciate the help.  I am on the same segment (192.168.1.10/24) and can get to 192.168.1.254 fine.

A repeat reset results in the same inability to login.

623
Views
0
Helpful
2
Replies
This widget could not be displayed.