Hey folks. I have been trying to get into one of these switches all day. I have taken all the neccesary steps, reset it to default, waited for the port to start blinking etc.. the problem is i am getting no gateway from the switch. i and getting an ip and a subnet, no gateway. i hve downloaded and installed the patch tool as this apprently is a known issue, but it says it cannot determine the ip of the device. i have looked up what ip it gave me, and set a static gateway, but this hasnt worked at all. i have worked with these before and have never had any issues getting in. i have tried it on windows 7 and windows xp. i'm about out of ideas.
yeah it is weird because it is the first one i've run into that has done this. I'm not sure why you would assume it is grey market, but it isn't. It was bought from Cisco, we have alot of them, and this one wasn't needed in another site, so i am trying to configure it to be used at a new spot.
the CE500 has a gui built in to configure it. I am not aware of any other management software for it, but would welcome it if there is some
Sx550X, Sx350X, Sx250: PSE will Supply Power to Catalyst PSE Ports
May 31, 2016
June 5, 2017
Configure Remote Network Monitoring (RMON) Events Control Settings on a Switch through the Command Line Interface (CLI)
Remote Network Monitoring (RMON) was developed by the Internet Engineering Task Force (IETF) to support...