Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Users might experience few discrepancies in Search results. We are working on this on our side. We apologize for the inconvenience it may have caused.
New Member

Cisco SG200-50 GigaBit Smart Switch - can't upgrade FW

Hi,

I have tryed to upgrade the FW but get this message :

7339520
Copy failed
Copy: SW code file is over sized

 

I tryed to upgrade to Release 1.4.0.88 from release 1.3.7.18

 

The boot loader is version 1.0.0.1

Hope som one can help me to upgrade the FW.

Br. Torben Grosen

 

1 ACCEPTED SOLUTION

Accepted Solutions
New Member

TorbenVejle, My name is

,

 

My name is Ismael. Iam with the Small Business Support Center. From my understanding you have tried firmware upgrade and its not uploading. I like to suggest to upgrade the bootcode first before attempting the firmware. Bootcode can be found on the same zip folder as the firmware. I have tried the same in my lab with SG300 with an initial bootcode and then i upgraded it to 1.3.5.06  allowing for the firmware to upload.  So give it a try and let me know how it turns out.

9 REPLIES
New Member

Hi Iarroyo,Thanks for the

Hi Iarroyo,

Thanks for the mail. How do I upgrade the bootloader ?

Br. Torben Grosen

 

New Member

Hi Iarroyo,Thanks for the

Hi Iarroyo,

Thanks for the mail. How do I upgrade the bootloader ?

Br. Torben Grosen

New Member

TorbenVejle, My name is

,

 

My name is Ismael. Iam with the Small Business Support Center. From my understanding you have tried firmware upgrade and its not uploading. I like to suggest to upgrade the bootcode first before attempting the firmware. Bootcode can be found on the same zip folder as the firmware. I have tried the same in my lab with SG300 with an initial bootcode and then i upgraded it to 1.3.5.06  allowing for the firmware to upload.  So give it a try and let me know how it turns out.

New Member

Hi Iarroyo,Thanks for the

Hi Iarroyo,

Thanks for the mail. How do I upgrade the bootloader ?

Br. Torben Grosen

New Member

I have now upgrade fw and

I have now upgrade fw and boot loader using a ftp server.

Thanks :-)

New Member

Hi Iarroyo,  I am facing the

Hi Iarroyo,

  I am facing the same problem now.  Could you send the bootloader to me?  Thanks!

Leung

New Member

ahming000, If your model

ahming000,

 

If your model switch is the sg200, higher than 8 ports the firmware 1.4.0.88 would have the bootcode. Its the file named sx200_boot-13506.rfb.  This firmware can be found under Cisco.com, downloads. This same file would have to be uploaded via a TFTP server only.

New Member

Hi,I'am using SG200-50P 50

Hi,

I'am using SG200-50P 50-Port Gigabit PoE Smart Switch. I tried to upgrade the firmware as mentioned above. Upload the boot code first and then again try to upload the firmware upgrade. But it still keep giving the error "SW code file is over sized".

New Member

How do you upgrade the

How do you upgrade the bootloader?  Can it be done via http or ftp?  If so any directions would be great

2289
Views
5
Helpful
9
Replies
CreatePlease to create content