Cisco SG500 in layer 3 mode - configuration of different VLANS
Calling to get some help because I'm going somewhere without really knowing what I'm doing ! Just bought the Cisco SG500-28 for me at home and want to use it in L3 mode to learn the most as I can (my knowledge is more Windows servers/apps based). All network masks are /24
What I want to have :
* 3 different VLANs : 10 - Internet / 20 - Clients / 30 - Servers
* 3 different IP ranges : 192.168.10.XX (range on my Internet modem, used for external computers) / 192.168.20.XX for client computers and 192.168.30.XX for server & network devices.
* VLANs 20 & 30 needs to be able to communicate with each others. VLAN 10 needs to be "isolated"
* Use a VM as firewall between VLAN 10 & 20/30
What I've already done so far :
* Configured all VLANs
* Configured an interface on VLAN 30 (192.168.30.1)
* Configured an interface on VLAN 20 (192.168.20.1)
* Configured ESX+switch ports with tagged VLAN 10 & 30 (with the necessary vSwitches)
What I'm really lacking is :
* How to configure routing so VLANs 20/30 have access to Internet by using my firewall in VLAN 30 (address 192.168.30.6)
* How to ensure that VLAN 10 is "isolated", so no client from this network can have access to VLANs 20/30.
Hope somebody can help me a little bit, documentation is unfortunately not really helping in this matter !
Sx550X, Sx350X, Sx250: PSE will Supply Power to Catalyst PSE Ports
May 31, 2016
June 5, 2017
Configure Remote Network Monitoring (RMON) Events Control Settings on a Switch through the Command Line Interface (CLI)
Remote Network Monitoring (RMON) was developed by the Internet Engineering Task Force (IETF) to support...