Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

Cisco SLM 2008, automatically change port setting (enable/disable)

Is there a way to automatically change the port state (SLM 2008 switch) from enabled/100MB/1000MB  to the disabled state?

The setting change must occur on certain times of the day.

Or, if possible, based on port statistics (number of Mbytes sent/received).

For example by running a script on the switch itself,  or on a device connected to the switch (PC)?

4 REPLIES
Cisco Employee

Re: Cisco SLM 2008, automatically change port setting (enable/di

on a PC

you might want to look into an SNMP management system which can be scripted

or use Radius authentication to de-authorize the port at specific times

Community Member

Re: Cisco SLM 2008, automatically change port setting (enable/di

Does the SLM2008 support SNMP?

Cisco Employee

Re: Cisco SLM 2008, automatically change port setting (enable/di

sorry, no SNMP

my fault


you need to invest into a fully managed switch, seems the SLM series is too leightweight for that

Cisco Employee

Re: Cisco SLM 2008, automatically change port setting (enable/di

i got confused

The SLMxxxS series has SNMP

the SLMxxxx has no SNMP

1183
Views
0
Helpful
4
Replies
CreatePlease to create content