Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

CLI for SE2010

Hi Team,

We just purchased this device and was curious if the firmware 3.0.2.0 or 3.0.1.0 has the CLI functionality like the Sx300 models with 1.1.2.0.  I find it easier to configure via CLI then the WebUI.

Please advise.

Thanks for any input

3 REPLIES
Green

CLI for SE2010

Hello Eisada,

There is a backdoor CLI for the SGE/SFE2000/2010 switches. However, the feature is unsupported and not recommended to use. Additionally, if you enable the CLI view on the console, there is not an exit command to go back to the menu driven supported configuration.

To access this configuration you can telnet to the switch (if you enable Telnet under the Bonjour tab) or console the switch. Authenticate as you normally would.

Press  ctrl+z  at the same time then type LCLI and hit enter. This will toggle the CLI and a 'normal login'.

-Tom

-Tom Please mark answered for helpful posts http://blogs.cisco.com/smallbusiness/
Highlighted
New Member

CLI for SE2010

I meant SGE2010.

Green

CLI for SE2010

My response is still valid.

-Tom

-Tom Please mark answered for helpful posts http://blogs.cisco.com/smallbusiness/
406
Views
0
Helpful
3
Replies
CreatePlease login to create content